Aube Technologies TH108PLUS/U User Manual

TH108PLUS 400-108-008-A 5/10/06 1/2
This thermostat can be used to control an electric heating system
such as a baseboard heater, a radiant ceiling, a radiant floor, a con-
vector, etc.
The thermostat cannot be used with the following:
• a resistive load under 2 A
• a resistive load over 12.5 A
• systems driven by a contactor or a relay (inductive load)
• fan-equipped heating systems
• central heating systems
SUPPLIED PARTS
• One (1) thermostat
• Two (2) 6-32 mounting screws
• Two (2) solderless connectors
TURN OFF POWER OF THE HEATING SYSTEM AT THE MAIN
POWER PANEL TO AVOID ELECTRIC SHOCK.
Loosen the screw holding the control module to the base. The screw
cannot be completely removed. Lift the control module to remove it
from the base.
Make the appropriate connections. Please note that the thermostat
wires are non-polarized; either wire can be connected to either termi-
nal.
NOTE: All cables and connections must conform to the local electri-
cal code. Special CO/ALR solderless connectors must be used when
connecting with aluminium conductors.
Align and affix the base to the
electrical box.
Set the switch at the back of the remov-
able part of the thermostat to °C or °F.
Replace the front part of the thermostat
on the base and secure it in place with
the screw.
NOTE: Keep the air vents of thermostat
clean and unobstructed at all times.
n
Description
1.
o
Installation
2.
Temperature
display
Percentage of
heating time *
Temperature
adjustment
buttons
* The thermostat displays the percentage of heating time required to
maintain the desired temperature. For example, is displayed when
heating is activated 40 percent of the time.
2-wire installation
4-wire installation
TH108PLUS
User Guide
Electronic Thermostat

Aube Technologies TH108PLUS/U Specifications

General

Type	Programmable Thermostat
Voltage	24V
Temperature Range	5°C to 30°C
Display	LCD
Compatibility	Conventional and Heat Pump Systems
Programming	7-Day Programmable
Battery	2 x AAA
Maximum Load	1.5A

Summary

Product Description and Components

Description of Thermostat Functionality

Details the thermostat's use for electric heating systems and lists incompatible systems.

Installation Guide

2-wire Installation

Illustrates the connection diagram for a 2-wire thermostat installation.

4-wire Installation

Illustrates the connection diagram for a 4-wire thermostat installation.

Temperature Display and Setting

Viewing and Adjusting Setpoint

Explains how to view and change the desired temperature setting.

Operational Features and Specifications

Power Outage Behavior

Describes how the thermostat retains its setpoint during power interruptions.

Technical Specifications

Lists the electrical, operational, and environmental specifications of the thermostat.

Troubleshooting and Support

Common Thermostat Issues and Solutions

Provides solutions for common problems like heating issues or display anomalies.

Warranty Information

Outlines the product warranty terms and conditions.

Customer Assistance Contact

Provides contact details for technical support and inquiries.