To Next Page

To Previous Page

To store current program back to recipe b2, long press SET, set LoCK=2, choose b2, press set to

confirm and exit. Now your current program is stored as recipe b2.

8.4 Recall your recipe to current program (Single-step Mode)

Before you input your set temperature, check the PrG = off (accessed by LoCK code “3”).

Long press SET, set LoCK=1, choose b2, press set to confirm and exit.

Now the C-1 from the recipe b2 is recalled back to your current program. The controller will start

run at this temperature setting.

8.5 Advanced examples

This example will show you how the PrG mode can affect the saved and current recipe/program.

1) Set PrG = on, select “b1” recipe:

C-1=120, t-1=2.0;

C-2= 290, F-2=160;

C-3=130, F-3=30.0;

2) Change PrG = off, now the current single-step program is:

C-1: 120.

3) Set current C-1 to 200, then store current program back to recipe b1. Now the b1 recipe is:

C-1: 200.

4) Change PrG = on, current b1 recipe is:

C-1=200, F-1=2.0;

C-2=190, F-2=160;

C-3= 130, F-3=30.0.

9. Factory reset function

WARNING! This function will restore all the parameters (including receipts in the memory) back

to factory default. Please write all the necessary settings down.

To reset, under the normal operating mode, press and hold SET key for 2 seconds until LED

display “LoCK”, and then release the SET key. The display will show “0” then. Use “+” key to

adjust the number to 666 and press SET key again to confirm. The display will show as “lnlE”,

then it will show as “off”. Press “+” key once to change “off” to “on”. Press SET key to confirm

factory reset. The display will show “----” then “8.8.8.8.” When you see this display back to normal

operating mode, factory reset completed. Please check Figure 14 for reset flow chart.

Auber WS Series User Manual

Questions and Answers: