Audi 2008 A4 - Page 17

– Remove and discard the grommets -arrow- on the left and
right side of the vehicle.
– Guide the advanced wires of the retrofit wiring harness from
the vehicle interior through the holes and insert wire grom-
mets.
– Assemble the shield plate, at the same time being aware of
the position of the wires below and at the edge of the shield
plates -arrow-.
Assembling the exhaust tips
– Select the punch point to match the body version and drill a
∅ 4.0-mm hole.
A - Coupé/Cabrio
B - Saloon/Avant and Sportback vehicles from model year 2012
C - Sportback vehicles from model years up to and including
201
1
– Note the installation position of the actuators and insert and
rivet the exhaust tips ⇒ Fig. “Aligning the exhaust tips” on
page
16
Assembling the actuators
– Position the mountings onto the actuators.
Installation instructions - Audi A4/A5 (B8 series) 2008 ▶
Edition 1
1/2012
3 Sequence of operations
15