Audi 2008 A4 - Page 8

– Loosen the fuse carrier F -SF- and unclip the fuse carrier -
E-.
– Unpin the lilac/white wire and pin it into the connector hous-
ing 1J0.972.751 provided.
– Pin the open wire end lilac/white into the vacated slot in re-
lay carrier -E-.
– Connect the two free connectors, making sure they engage.
● Up to and including model year 2011:
– Unclip fuse carrier ST4.
– Unpin the wire from the fused outgoing circuit in chamber 3
– Pin the purple/white wire from the AGA wiring harness into
the vacated chamber
– Pin the unpinned wire from the vehicle wiring harness into
the connector housing provided (1J0.972.751).
– Pin the unpinned wire from the vehicle wiring harness into
the connector housing provided (1J0.972.751) and connect
to the connector (1J0.972.762) from the AGA wiring har-
ness.
– Check for secure engagement.
– If there is no fuse in slot 3:
– Pin the purple/white wire from the AGA wiring harness into
the empty slot for fuse 3 (fuse carrier ST4).
– Insert fuse 15A (N.017.131.12) into slot 3.
– Screw the earth wire onto the earth point on the right-hand
side of the luggage compartment.
Installation instructions - Audi A4/A5 (B8 series) 2008 ▶
Edition 11/2012
6
3 Sequence of operations