Audi A3 2024 - Page 132

Driver assistance
Display in the speedometer
The display in the speedometer is not available in
all layouts*.
@ Marking for the set speed
@® Current vehicle speed
® Available speed range for adaptive cruise as-
sist
(example)
Image in the Driver assistance display
The image in the Driver assistance display only
appears if it was opened in the trip computer
> page 18.
Messages and settings
Your vehicle
Detected vehicle driving ahead
Messages and settings
Set target distance
If you fall below the set distance, the dis-
tance bars turn red from the bottom upward.
Lane departure warning availability
OO
©©0OO®O
Availability of lane guidance for adaptive
cruise assist
Indicator lights
EB- The speed/distance control is active. No
vehicles were detected ahead. The stored speed
is maintained
EBV- The speed/distance control is active. A vehi-
cle was detected ahead. The system controls the
speed and distance from the vehicle driving
ahead, and accelerates and brakes automatically.
HI- The speed/distance control is active but the
vehicle is not ready to drive. A vehicle was de-
tected ahead. Your vehicle is stationary and will
not start driving automatically.
BB- The speed/distance control is active but the
vehicle is not ready to drive. No vehicles were de-
tected ahead. Your vehicle is stationary and will
not start driving automatically.
B- Take over. The braking power is not suffi-
cient > page 132, Brake intervention request or
the safe start monitor is providing a warning
page 136.
[- Lane guidance is active.
130
[WB - Take over steering. The system limits have
been reached ® page 133, Steering intervention
requests.
[l- Lane guidance is switched on but it is not ac-
tive © page 132, Lane guidance limitations.
EBV) Take over steering. No steering detected
or a system limit has been reached @ page 133,
Steering intervention requests.
Observe the safety precautions and note the
limits of the assist systems, sensors, and
cameras page 115 to > page 178.
Using adaptive cruise assist
Applies to: vehicles with adaptive cruise assist
Fig. 89 Operating lever: changing the speed
Switching on
» To switch on the adaptive cruise assist, pull the
lever up to position @ until it engages.
Storing the speed and activating regulation
If you have switched the system on, you can set
the current speed as the “regulated speed” and
activate regulation:
OwnersManuals2.com