Audi A3 2024 - Page 53

8v0012721BE
Opening and closing
Only a maximum of three systems can be dis-
played in the notification center + page 25. If you
would like to have all systems displayed, press
93
88.
Renaming programmed systems
You can rename the programmed systems ac-
cording to your preferences (names may have a
maximum of 10 characters).
» Ifyou have programmed your system, follow
the instructions in the MMI. Or
If you would like to change the name at another
time:
> Applies to: MMI: Select on the home screen:
VEHICLE > Settings & Service > Garage opener.
» Press the 4 button.
> Press the 7 button for the system that you
would like to rename.
» Select: Rename. If necessary, delete the preset
name, such as Garage door opener 1.
» Follow the instructions in the MMI.
Deleting programmed systems
The programmed systems can be deleted individ-
ually or all at once.
» Applies to: MMI: Select on the home screen:
VEHICLE > Settings & Service > Garage opener.
» Press the Z button.
» To delete an individual system, press the L]
button for the desired system. If the checkmark
¥ is set, select: Delete.
» To delete all systems, select: All > Delete.
— Make sure the batteries in the hand trans-
mitter are charged before starting the pro-
gramming process.
= The programming process may take up to
30 seconds. It may be necessary for the
hand transmitter to be pressed again in the
meantime.
~The garage door opener may need to be
synchronized with the system after pro-
gramming. Follow the manufacturer's in-
structions for doing this.
In some cases, the system may need to be
programmed in a different mode (“D mode”).
— Switch the ignition on.
— Applies to: MMI: Select on the home screen:
VEHICLE > Settings & Service > Garage
opener.
—Press and hold the desired button @).
= Select Yes, in D mode and follow the in-
structions on the MMI.
51
OwnersManuals2.com