Audi A3 2024 - Page 94

Driving
must secure your vehicle against rolling using ad-
ditional measures.
» Only park the vehicle on a level surface.
» Use suitable objects to block the front and rear
wheels.
Set the parking brake before selecting the “P” se-
lector lever position. This prevents too much
stress from being put on the locking mechanism
when parking on a steep surface.
— Always set the parking brake when leaving
your vehicle, even if for a short period of
time. If the parking brake is not set, the ve-
hicle could roll away, increasing the risk of
an accident.
— Do not leave your vehicle unattended while
the engine is running, because this increases
the risk of an accident.
~ If the parking brake is set, it can release au-
tomatically when the accelerator pedal is.
pressed. To reduce the risk of an accident,
do not inadvertently press the accelerator
pedal and always shift into “P” when the ve-
hicle is stopped.
~ If you leave the vehicle, switch the ignition
off and take the key with you. This is espe-
cially important when leaving persons or an-
imals in the vehicle. Otherwise, the vehicle
could start unintentionally, the parking
brake could release, or electronic equipment
could activate, which increases the risk of an
accident.
— No persons or animals should be left ina
locked vehicle. Locked doors make it more
difficult for emergency workers to enter the
vehicle, which puts lives at risk.
~ If you do not begin driving immediately after
releasing the brake pedal, your vehicle may
begin to roll backward. Press the brake ped-
al or set the parking brake immediately.
If you have to stop on an incline, always press
the brake pedal to hold the vehicle in place to.
reduce the risk of the vehicle rolling back-
ward. Do not try to hold the vehicle in place
92
by pressing and holding the accelerator pedal.
The transmission can overheat, which increas-
es the risk of damage.
Hill hold assist
If you take your foot off of the brake pedal when
driving on hills, the braking force will be held for
several seconds. At that time, you can start driv-
ing without the vehicle rolling backward.
Requirement: the driver's door must be closed,
the engine must be on, and the vehicle must be
traveling uphill.
» To activate hill hold assist, press and hold the
brake pedal for several seconds while the vehi-
cle is stationary.
—If you do not begin driving immediately after
releasing the brake pedal, your vehicle may
begin to roll backward. Press the brake ped-
al or set the parking brake immediately.
~The hill hold assist cannot hold the vehicle
on inclines in every scenario (for example,
on slippery or icy ground).
The following messages may appear depending
on the vehicle equipment:
BB itt hold assist: unavailable
The hill hold assist is temporarily unavailable.
Press the brake pedal to secure the vehicle from
rolling away unintentionally.
OwnersManuals2.com