Audi A4 - Page 133

adaptive cruise control (ACC) 131
Controls Safety Driving tips General maintenance Self-help Technical data
Applies to vehicles: with adaptive cruise control
Switching the system on and off
– Pull the control lever to position ⇒ fig. 138 to switch
on the system.
– Press the control lever to position (click stop engaged)
to switch the system off.
Applies to vehicles: with adaptive cruise control
Setting the speed
Important: The system must be switched on.
– Drive at the desired speed. The speed must be in the
range between 30 and 200 km/h.
– Press the button -arrow- ⇒ fig. 139 to confirm the
target speed you wish to store.
When the button is released, the current speed is stored in the
memory and the vehicle will then maintain this speed.
One or two red diodes will light up in the speedometer dial
⇒ page 134 to mark the speed which is currently stored in the
system. At the same time, the speed will briefly be displayed in the
system status indicator ⇒ page 136.
Note
For safety reasons, the speed setting will be deleted when the igni-
tion is switched off.
Applies to vehicles: with adaptive cruise control
Setting a new speed
The speed can be altered without touching the acceler-
ator or the brake.
Fig. 138 Control lever
for: Switching the
system on and off
A
1
A
2
Fig. 139 Control lever
for: Setting speed
SET
SET
Fig. 140 Control lever
for: Setting a new
speed
document_0900452a81b1b9de.book Seite 131 Donnerstag, 26. Juli 2007 9:16 09