Fuses and bulbs 315
Controls Safety Driving tips General maintenance Self-help Technical data
Changing bulb / installing bulb carrier
– Renew the defective bulb (pull to remove from plug-in
holder or turn to remove from bayonet holder)
⇒ page 305.
– Insert the bulb carrier into the rear light. Make sure you
hear the retaining tab click into place.
– Fit the cover back in the interior trim so that it engages.
– Put the screwdriver back into the tool kit.
– Make sure that all bulbs for the rear lights are working.
Applies to vehicles: with halogen main beam headlights
Number plate light
Removing number plate light
– Take the screwdriver out of the vehicle tool kit
⇒ page 283.
– Insert the flat-blade side of the reversible screwdriver
insert into the slot on the number plate light ⇒ fig. 310.
– Using the screwdriver, start by pressing the number
plate light to the right -arrow 1- and then pull the number
plate light downwards from this position -arrow 2- and
out of the opening.
Fig. 309 Bulb carrier
Fig. 310 Boot lid:
Removing number
plate light
Fig. 311 Number plate
light: Retaining
element
document_0900452a81b1b9de.book Seite 315 Donnerstag, 26. Juli 2007 9:16 09
To Next Page
Loading...
