Audi A4 - Switching Display and Acoustic Signals on and off; Towing Bracket

Parking aid 177
Controls Safety Driving tips General maintenance Self-help Technical data
Applies to vehicles: with Audi parking system/plus/advanced
Switching display and acoustic
signals on and off
The settings for the graphic display* and acoustic signals
are controlled via the sound system or MMI*.
– Select: Function selector button > Audi parking
system.
Display*
• off - The parking aid gives only acoustic warning signals when it
is activated.
• Graphic - The graphic display appears when reversing and
driving forwards.
• Rear View* - The picture from the reversing camera is shown
when reversing and driving forwards.
• Automatic* - The picture from the reversing camera is shown
when reversing and the graphic display is shown when driving
forwards.
Warning beeps
• Rear volume - Volume of the rear sensors
• Rear frequency - Pitch of the rear sensors
• Front volume* - Volume of the front sensors
• Front frequency* - Pitch of the front sensors
You will hear a short test tone each time you make a new setting.
Note
• You can also change the warning beep settings directly from the
graphic display* or reversing camera* picture. Simply press the
control button for *.
• New settings are not activated until you switch on the parking
aid again.
• The settings will be automatically stored and assigned to the
remote control key.
Applies to vehicles: with Audi parking system/plus/advanced and towing bracket
Towing bracket
In towing mode, the rear parking sensors are NOT activated when
you select reverse gear or press the switch . This may not apply if
the power socket was NOT factory-fitted. This results in the
following restrictions:
Audi parking system*
There is no distance warning.
Audi parking system plus*
There is no rear distance warning. However, the system will still give
a warning when obstacles are detected while driving forwards. The
proximity graphic will switch over to towing mode.
Audi parking system advanced*
There is no rear distance warning. However, the system will still give
a warning when obstacles are detected while driving forwards. The
proximity graphic will switch over to towing mode. The image of the
Fig. 196 Display:
Settings for parking
aid
CAR
Settings
document_0900452a81b1b9de.book Seite 177 Donnerstag, 26. Juli 2007 9:16 09