Fuses and bulbs310
– Press the connector in the direction of the arrow
⇒ page 309, fig. 297 until the bulb engages.
– Check that the bulb is securely seated in the bulb
housing.
–Fit the cover.
– Install the headlight ⇒ page 306.
– Check whether the new bulb is working.
– Have the headlight settings checked.
Changing bulb for front fog lights
Applies to vehicles: with halogen main beam headlights
Preparations
The description for changing the bulb refers to the right fog
light; in principle the same procedure applies to the left fog
light.
– Switch off the ignition and the lights.
– Detach the trim cover ⇒ fig. 298 (pull it carefully in the
direction of the arrow).
– Remove the two securing screws ⇒ fig. 299 and pull the
fog light unit out of the bumper.
– Unplug the electrical connector.
Caution
The trim cover is secured to the bumper by several retaining hooks.
Do not use force when removing the trim cover to avoid damaging
it.
Fig. 298 Trim cover for
fog light
Fig. 299 Screws
securing fog light
document_0900452a81b1b9de.book Seite 310 Donnerstag, 26. Juli 2007 9:16 09
To Next Page
Loading...
