Audi lane assist146
Indicator lamp in instrument cluster
Active: The green indicator lamp confirms that the system is fully
functional. You will be warned if you are about to cross the lane
markings detected by the system.
Inactive: The yellow warning lamp indicates that the system is
switched on. However, you will not be warned if you cross the lane
markings. This can have the following causes:
• There is only one or no lane marking.
• The system cannot detect the lane markings (e.g. due to snow,
dirt, wet conditions or adverse light).
• There are more than two lane markings in the lane you are
driving in (e.g. in roadwork sections).
• The vehicle's speed is below 65 km/h, the speed at which the lane
assist system is activated.
• The lane is narrower than 2.5 m or wider than 5 m.
• The bend is too tight.
Note
• Make sure that the camera window ⇒ page 145, fig. 159 is not
covered with stickers or similar objects.
• Always keep the camera window clean. Usually it should suffice
to operate the windscreen wipers.
Applies to vehicles: with lane assist and on-board computer
Instrument cluster display
You can call up the display for the lane assist by repeatedly pressing
the button on the windscreen wiper lever. For more details
refer to ⇒ page 27.
When the lane assist is switched on, two lines indicate the lane
demarcations on the left and right of your vehicle.
Version : Monochrome display
• Solid red lines: The lane assist is switched on and ready to warn.
• One red line flashing (left or right): The lane assist warns you
before you cross the lane demarcation ⇒ fig. 160, A
Fig. 160 Instrument
cluster: lane assist
switched on and in
warning mode
Fig. 161 Instrument
cluster: lane assist
switched on but not
ready for warning
RESET
To Next Page
Loading...
