Audi A4 - Page 31

Driver information system 29
Controls Safety Driving tips General maintenance Self-help Technical data
need to keep below a particular speed when winter tyres are fitted,
etc.
The speed limit warning symbol  for speed warning 2 will appear
in the display if you exceed the pre-set speed. Unlike speed limit
warning 1, the warning symbol only goes out once the road speed
has dropped below the stored value again.
Setting speed limit warning 2 ⇒ page 29.
Note
Please bear in mind that, even with the speed warning function, it is
still important to keep a check on the car's speed with the speedom-
eter and to observe the statutory speed limits.
Applies to vehicles: with speed warning function
Setting speed limit warning 1
You can use the button to set, alter or cancel speed
limit warning 1.
Selecting speed limit
– Drive at the desired maximum speed.
– Press the button in the instrument cluster ⇒ fig. 22
for one second.
Clearing speed limit
– Drive the vehicle at a minimum of 5 km/h.
– Press the button for at least 2 seconds.
The speed warning symbol  lights up briefly in the display to
confirm that the selected speed has been stored. The speed limit
that has been set remains stored until another speed is set with a
brief push of the button, or until the memory is cleared with a long
push of the button.
When the speed limit has been cleared, the display will show a
crossed-out warning symbol .
Applies to vehicles: with speed warning function
Setting speed limit warning 2
You can use the sound system or MMI* to set, alter or
cancel speed limit warning 2.
– Select: Function selector button > Instrument
cluster > Speed warning.
• Speed warning on/off - to activate or deactivate the speed
warning function ⇒ fig. 23.
SET
Fig. 22 Detail of the
instrument cluster:
SET button
SET
SET
Fig. 23 Display:
Setting speed limit
warning 2
CAR
document_0900452a81b1b9de.book Seite 29 Donnerstag, 26. Juli 2007 9:16 09