Fuses and bulbs 313
Controls Safety Driving tips General maintenance Self-help Technical data
Changing bulbs
All bulbs can be changed easily after removing the rear
light.
– Detach the bulb carrier.
– Renew the defective bulb (pull to remove from plug-in
holder or turn to remove from bayonet holder)
⇒ page 305.
– Attach the bulb carrier.
– Re-install the rear light ⇒ page 313.
Applies to vehicles: with halogen main beam headlights
Installing rear light
The rear light is easy to re-install.
To re-install the rear light, follow the steps for removal in
reverse sequence.
– Plug in the electrical connector. Make sure you hear it
click into place.
– Insert the rear light into the rear light carrier ⇒ fig. 305.
– Press the rear light into the two rubber mountings as far
as it will go. The rear light must be flush with the body
contour.
– Use the screw to secure the rear light from the luggage
compartment.
– Make sure that all bulbs for the rear lights are working.
Caution
Take care when installing the rear light to make sure there is no
damage to the paintwork or any of its components.
Fig. 304 Rear light,
mounting plate is high-
lighted
Fig. 305 Installing rear
light
document_0900452a81b1b9de.book Seite 313 Donnerstag, 26. Juli 2007 9:16 09
To Next Page
Loading...
