@ Tips
To open the ga rage door, press the button,
but do not press it for longer ten seconds
or the Homeli nk modu le will switch to
programming mode .
Programming the transmitter
Applies to vehicles : with Home Link
Fig. 14 3 Distance betwe en the radiato r grill e and the
hand t ransmitte r
You can program the fixed code and rolling
code systems using the descr ibed procedure.
Programming the button
.. Turn the ign ition on .
.. There are two ways to program a button :
press the button that you wo uld like to pro-
gram . The MMI will display instruc t ions t o
guide you throug h the programm ing. Or
.. Select :
I CARI f unct ion but t on> (Car)* sys-
tems
cont rol but t on > Vehicle settings >
Garage door opener > Program garage door
opener .
.. Se lect the button t hat you would like to pro-
gram .
.. Follow the instructions in the MMI.
.. If the garage door open ing must also be
synchronized with the Homelink modu le,
refer to the owner's manual for t he ga rage
doo r open er.
Remote control units for garage door openers
in Canada are set to stop transmitti ng radio
frequency s ignals after two seconds . This time
may not be suff icient for th e Homelin k sys-
t em t o lea rn t he radi o fr equency s ignal. Per-
form all ot her st eps as descr ibed above .
Homelink 12 7
Erasing/ Clearing the programmed button
settings
.. To erase all of the prog rammed buttons at
the same time, select: !CAR! function button
>
(Car)* systems function key> Vehicle set-
tings
> Garage door opener > Clear pro-
gram settings > Yes.
The prog rammed but-
tons can not be erased individua lly. Repro-
gram the buttons if necessa ry .
.. Reprogram an individua l bu tt o n in t he same
manner th at yo u wou ld for t he o ne-time
prog ramm ing.
Displaying the version/status/country
code
.. Select: !CARI func t ion button> (Car)* sys-
tems
control button > Vehicle settings >
Garage door opener > Version information .
(D Tips
- The requ ired dist ance bet wee n t he hand
t ransm itt er a nd the Homel ink mo dul e in
the radiato r gr ille ~
fig . 143 depen ds on
t he system that yo u are prog ramm ing .
- Depending on the mo de l of t he ga rage
doo r opener, you may need to release t he
button on t he rem ote and press it again
when programming. When program-
m ing a new device, keep the button
pressed for at least 15 seconds bef ore
t rying again with t he t ransmitter in a dif-
fe re nt posit ion. Watch o ut for t he eme r-
gen cy fla sher dur ing t hat time.
To Next Page
Loading...
