.. Press inward strongly to the button side of
the cap to
remove it from the bumper
¢ fig . 220 .
.. Screw the towing loop in the threaded open -
ing and tighten it until it stops ¢fig. 221.
Remove the towing loop when you are done
using it and place it back in the vehicle tool
kit. Install the
cover in the bumper. Always
keep the tow ing loop in the vehicle.
A WARNING
If you do not screw the tow ing loop com-
pletely, it could come out of the threaded
hole while the vehicle is being towed cau s-
ing damage to the vehicle and possib le se-
rious personal inju ry.
Rear towing loop
Only install the rear towing loop when it is
needed.
0
Fig. 222 Rear bumper: cover
Fig. 223 Rear bumper: towing loop installed
There are threads located behind the right
side of the rear bumper where a towing loop
can be installed. The threads are located be-
hind a
cover.
Emergenc y s itu ation s 2 77
.. Remove the tow ing loop from the vehicle
too l kit .
.. Press inward strong ly to the button side of
the cap to
remove it from the bumper
¢fig. 222 .
.. Screw the towing loop in the threaded open-
ing and tighten it unt il it stops. The indica-
to r mark ing must be flush with the bumper
¢ fig. 223 .
Remove the towing loop when you are done
us ing it and place it back in the veh icle too l
kit. Always keep the towing loop in the vehi-
cle.
A WARNING
If you do not screw the towing loop com -
pletely, it could come ou t of t he threaded
hole while the vehicle is being towed caus-
ing damage to the vehicle and possible se-
rious pe rsonal injury.
loading the vehicle onto a flat bed truck
Fig. 22 4 Vehicle on flat bed t ruck
Front hook up
.. Align the vehicle with t he centerline of the
car carrier ramp .
.,. Attach the winch hook to the front towline
eye prev iously installed .
Rear hook up
.,. Align the vehicle with the center line of the
car carrier ramp .
.. Attach the winch hook to the rea r tow line
eye prev ious ly insta lled .
M
a,
N
0
0
"'
"'
To Next Page
Loading...
