Audi A6 2014 - Page 59

Remote Memory button
control
master
key
Driver Driver Front
passen-
ger
Seat X X X
Stee ring X X
wheel*
Both exterior
X X
rearview mir-
rors*
Remote control key
Applies to vehicles: with memory function
To ass ign t he driver's sea t settings to t he re -
mote cont rol key when locking t he vehicle, the
function must be swit ched on .
~ Select: I CARI funct ion button > (Car)* sys-
tems
con t rol button > Vehicle settings >
Seats > Driver seat > Remote control key >
On.
@ Tips
If yo u do not wa nt anot her d river's set-
t ings to be assigned t o the remote control
key, switch off the memory function usin g
the MMI or the
!OFF! button ce:> page 57.
Memory buttons
Applies to vehicles: with memory function
Fig. 53 Driver·s door: memory f unction buttons
The memo ry but t ons are located in the dr iv-
er's/fron t passenger 's* door.
Seats and storage 5 7
~ To store a seat ing profile, press the !SET!
button and the n one of the memory but-
tons.
~ To recall a seating profile, press and ho ld
the memory button until t he seat is adjust-
ed to the stored settings.
~ To swit ch the memory funct ion for the dr iv-
er or fro nt pa ssenge r off, pre ss the
!OFFI
button. The wo rd OFF lights up whe n t he
mem ory function is switc hed off. Sea ti ng
prof iles will not be stored.
WARNING
- For safety reasons, the seat setting
should only be recalled when the veh icle
is stationary - otherw ise you risk having
an accident.
- If necessary, you stop the process by
press ing the
!OFF! button or any of the
memory buttons.
Adjusting the front passenger seat in
the MMI
Applies to vehicles: with memory function
The driver can adjust the position of the front
passenger seat.
Adjusting the front passenger seat from
the driver's side
~ Select: !CARI function button > (Car)* sys-
tem s
control button > Vehicle settings >
Seats > Front passenger seat > Adjust seat
position .
~ You ca n now adju st the fron t passe nger sea t
using t he but tons on the dr iver's se at
q page 53, fig . 47 .
Matching the position of the driver's seat
~ To adjust th e front passenger seat to match
the dr iver's seat settings, select t he
ICARI
function button > (Car)* systems cont rol
but t on
> Vehicle settings > Seats > Front
passenger seat> Symmetry to driver seat.
~ Press and hold the contro l knob unti l the ad-
justment process is complete.