94 Aud i active lane assist
Activating and deactivating
Applies t o vehicles: with active lan e assist
Fig. 94 Turn signal lever: Active lane assist butto n
Fig. 95 Windshie ld: Active lane assist camera viewing
window
-
I
~
Press the ¢ fig . 94 button to activate or de-
activate the system. The indicator light .
or . in the instrument cluster will illumi-
nate or go out.
Instrument cluster indicator light
• Ready: The indicator light shows that the
system is ready to use . The system can now
warn you if you are about to cross a known
lane marker line .
• Not ready: The indicator light shows that
the system is turned on but unable to send a
warning . This can be due to the following :
- There is no lane marker line .
- The relevan t lane marker lines are not de-
tected (for example, markings in a construc-
tion zone or because they are obstructed by
snow, dirt, water or backlight ing) .
- The vehicle 's speed is below the speed need -
ed to activate it, which is about 40 mph (65
km/h) .
- The lane is narrower than about 8 ft . (2 .5 m)
or wider than 4 .5 m.
- The curve is too sharp .
- The driver's hands are not on th e steering
wheel.
(D Tips
Make sure the camera's field of view
¢ fig. 95 is not obstructed by stickers, de-
posits or anything else. For information on
cleaning, refer to ¢
page 210.
Active lane assist display in the
instrument cluster
Applies to vehicles: wit h act ive lane assist
Fig. 96 Display: Active lane assist is switched on and is
warning
Fig. 97 In strume nt clust er: Active l ane assist is switch ·
ed on but not ready t o provide warnings
You can call up the active lane assist display
using the buttons in the multifunction steer-
ing wh eel ¢
pag e 24.
An additional indicator appears in the Head-
up Display*.
When active lane assist is switched on, the
system indicates which lines are detected by
displaying solid lines on the left and/or right
side of your vehicle: .,..
To Next Page
Loading...
