Audi A6 2024 - Page 55

4K1012721BA
Opening and closing
Applies to: vehicles with garage door opener
Requirements: the remote control transmitter
must be programmed © page 53, Program-
ming, the vehicle must be within range of the
system, and the ignition must be switched on.
There are multiple options to open or close the
system (such as the garage door).
> If you have only programmed one remote con-
trol transmitter, press the -@ button on the
lower display. Or
> If you have programmed multiple remote con-
trol transmitters, press the -@ button on the
lower display and then press the respective sys-
tem button. Or
> Applies to: vehicles with programmable steer-
ing wheel button: If you have configured the
programmable steering wheel button, press
the % button © page 33. Or
> Applies to: vehicles with location pairing: If you
have programmed Location pairing, press the
button for this in the upper display (notification
center page 26). As you approach the system,
the button is displayed on the MMI.
If transmission was successful, the message:
Send to: XXX will appear.
Applies to: vehicles with garage door opener
You can program both fixed code and rolling code
systems in the MMI using the procedure that is
described.
Requirement: the ignition must be switched on.
Programming the system
Applies to: MMI
Requirement: the hand transmitter must be
present and the vehicle must be within range of
the system (such as the garage door) that you
would like to program.
» Ifyou are programming the garage door opener
for the first time, press the - button on the
1 Only applies to rolling code systems
lower display. Follow the instructions in the up-
per display. Or
> If you would like to program other systems, se-
lect on the home screen: VEHICLE > Settings &
Service > Garage opener. Select the desired
button: @). Follow the instructions in the MMI.
» If you would like to reprogram systems that are
already programmed, select on the home
screen: VEHICLE > Settings & Service > Garage
opener. Press the % button and select 7 for
the system to be reprogrammed. Select: Pro-
gram. Follow the instructions in the MMI.
With some systems, the garage door opener will
be immediately available after programming
With other systems, the garage door opener
must also be synchronized.
Synchronizing”)
Requirement: the hand transmitter must already
be programmed and the vehicle must be within
range of the system (such as the garage door).
If the system synchronization is performed di-
rectly after the programming procedure, follow
the instructions on the MMI.
If you would like to sync at a later time:
» Applies to: MMI: Select on the home screen:
VEHICLE > Settings & Service > Garage opener.
» Press the button for the system that you would
like to synchronize.
> Follow the instructions in the MMI.
Location pairing
Applies to: vehicles with location pairing
For easier operation, you can program your sys-
tem's location.
Requirements: the respective hand transmitter
must be programmed © page 53 and the vehicle
must be located in front of the system.
» Ifyou have programmed your system, follow
the instructions in the MMI. Or
If you would like to set up location pairing at an-
other time:
53
OwnersManuals2.com