Audi A6 2024 - Page 92

Storage and convenience
— Applies to: vehicles with partition net: Let
the partition net roll up slowly to reduce the
risk of damage.
~The tire pressure must be adapted to the
load page 279.
~ You can purchase straps at specialty stores.
Power luggage compartment cover
Applies to: vehicles with power luggage compartment cover
Fig. 72 Luggage compartment: removing the luggage
compartment cover
Observe the safety precautions page 88.
If you open the luggage compartment lid, the
power luggage compartment cover will move in-
to position @ or @).
> To attach the luggage compartment cover, pull
the cover out. Guide the cover past position (@)
and install it at position @).
» To remove the luggage compartment cover, de-
tach the cover and allow it to roll up.
> Pull the lever @) firmly in the direction of the
arrow and remove the cover upward.
90
» To install the luggage compartment cover,
place the cover in the side trim panel mount on
the left side.
» Press the cover down into the right mount until
it locks into place.
Folding the outer backrests
Applies to: vehicles with folding backrests
Fig. 73 Outer backrest: release lever, latching indicator
red marking and lock"
‘Applies to: Avant/allroad:
Fig. 74 Luggage compartment: release lever
The rear seat backrests can be folded forward ei-
ther separately or together.
Observe the safety precautions ~ page 88.
Folding the outer rear backrests forward and
backward
> Pull the release lever (@) or @) in the direction
of the arrow to fold the backrest forward.
> After the transport, fold the backrest up again
until it latches and the red marking @)is no
longer visible.
Locking the outer backrests
Applies to: sedan
To prevent access to the luggage compartment
from the vehicle interior, the backrests can be >
OwnersManuals2.com