Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Push a small screwdriver through the oil seal and pull it out.
– Lubricate outer circumference and space between sealing lips
of new oil seal with ATF.
– Fit oil seal onto selector shaft.
• Installation position: the open side of the oil seal should face
the gearbox.
– Drive in oil seal onto stop using thrust piece -T10135- . Take
care to keep seal straight when installing.
– Before installing gearbox selector lever, knock back roll pin
through lever in opposite direction.
– Push gearbox selector lever onto selector shaft and drive in
roll pin.
Audi A6 2005 ➤ , Audi A8 2003 ➤
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
156 Rep. gr.39 - Final drive - front differential
To Next Page
Loading...
