Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Turn cylinder „E“ upside down.
WARNING
Wear safety goggles.
– Carefully press piston „E“ out of cylinder „E“ using compressed
air (cover oil drilling on opposite side with your finger).
Assembling
Caution
Check components of clutch „E“ for traces of wear and damage
⇒ „3.8 Clutch E “, page 176 .
– Renew O-rings -2- and -4- for piston „E“ -item 3-.
– Push piston „E“, -item 3- into cylinder „E“, -item 1- as far as
stop.
– Fit dished spring -5-.
– Renew O-ring -6- in retaining plate -7-.
– Insert retaining plate -7-.
– Insert retaining plate -8-.
• The angled outer rim of the retaining plate faces upwards to‐
wards circlip -9-.
– Press retaining plate down using workshop press with assem‐
bly jig -T10277- .
Caution
Take care not to stretch circlip too far when installing.
– Renew circlip -1- and install new circlip with care.
– When installing, make sure that circlip is seated securely all
round in groove on cylinder „E“.
– Release workshop press.
Audi A6 2005 ➤ , Audi A8 2003 ➤
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
5. Dismantling and assembling body „II“ 85
To Next Page
Loading...
