Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Use both hands to pull clutch pack upwards in clutch „E“ as far
as stop.
– With clutch pack pulled up as far as stop, measure distance
between upper rim of cylinder „E“ and outer plate at one of the
points marked (second mechanic required).
– Repeat measurement at the two remaining markings on the
outer plate.
– Determine average value from the three measurements with
clutch pack pulled up as far as stop.
– Determine clearance using the following formula:
Mean value of measurements under load
(value 1 + value 2 + value 3) : 3
– Mean value of measurements with clutch pack pulled up
as far as stop
(value 1 + value 2 + value 3) : 3
= Clearance
– Subtract mean value of measurements with clutch pack pulled
up as far as stop from mean value of measurements under
load.
Clearance:
• Specification: 1.84 ... 2.37 mm
If result does not match specification:
– Determine new circlip -1-.
Note
-Item 2- can be disregarded.
• If clearance is below specification: insert thinner circlip of ap‐
propriate thickness.
• If clearance is above specification: insert thicker circlip of ap‐
propriate thickness.
Available circlips - Thickness of circlips in mm
1.80 2.60 3.40
2.00 2.80 3.60
2.20 3.00
2.40 3.20
– Check clearance again after inserting circlip.
Audi A6 2005 ➤ , Audi A8 2003 ➤
Servicing automatic gearbox 09E, four-wheel drive - Edition 12.2011
5. Dismantling and assembling body „II“ 87
To Next Page
Loading...
