Audi Q3 2016 - Cruise Control System; Activate Cruise Control; Setting Cruising Speed; Changing Speed

Cruise Control
Activate
To activate, pull the control stalk toward you
(ON position).
Set Cruising Speed
Learn more about
Cruise Control
TEXT Q3CRUISE16A
to 38981
Do not text and drive.
Message and data rates may apply.
At your desired speed, press the SET button at the
end of the stalk. The set speed and the illuminated
CRUISE icon are shown in the Driver Information
Display upon activating.
Changing Speed
There are three ways to change your speed:
► Accelerate or decelerate, then press the SET
button again.
► To increase/decrease speed in 1 mph increments,
tap the stalk up or down.
► Hold the stalk up or down to increase/decrease
speed in 5 mph increments; release when desired
speed is reached.
Cancel/Resume
1. Press the brake pedal or push the stalk slightly
away from you (CANCEL position).
2. The CRUISE light will go off.
3. To resume, pull the stalk towards you; you will
return to your set speed.
Your most recently set speed appears as a small icon in the
Driver Information Display. It remains in memory until you
turn Cruise Control or your Audi off.
Important Safety Instructions and Warnings: Cruise Control
► Always pay attention to the traffic around you when the Cruise Control is in operation. You are always responsible for your speed and the distance
between your vehicle and other vehicles.
► For safety reasons. Cruise Control should not be used in the city, in stop-and-go traffic, on winding roads and when road conditions are poor (such
as ice, fog, gravel, heavy rain and hydroplaning), because this increases the risk of an accident.
► Switch the Cruise Control off temporarily when driving in turning lanes, highway exits or in construction zones.
► Please note that unconsciously "resting" your foot on the accelerator pedal prevents the Cruise Control from braking. This is due to the control
system being overridden by the driver's acceleration.
► If a brake system malfunction such as overheating occurs when the Cruise Control system is switched on, the braking function in the system may
be switched off. The rest of the Cruise Control system functions remain active as long as the indicator light is on.
► You should only return to the saved speed if it is not too fast for the current traffic conditions - risk of an accident!
Cruise Control