- If the position or the installation angle
of a camera was changed, after a coll i-
sion for example, do not continue to use
the system for safety reasons . Have it
checked by your authorized Audi dealer-
ship .
- Use the
Rear mode and the Corner view
(rear)
mode only when the rear lid is
completely closed, otherwise the image
in the display will be inaccurate.
- Objects and obstacles
above the camera
are not displayed.
- Camera lenses enlarge and distort the
field of vision. The objects appear both
altered and inaccurate on the screen.
(0 Note
- Always read and follow the applicable
warnings ¢ 0
in General information on
page 143 .
- The MMI display shows the direction in
which the rear of the vehicle is traveling
based on the steering wheel angle. The
vehicle front swings out more than the
vehicle rear. Maintain plenty of distance
so that your outside mirror or a corner of
your vehicle does not collide with any ob-
stacles .
@ Tips
If the rear lid is open, the image in the
rearview camera is displayed without ori-
entation lines and without blue s urfac es.
Switching on or off
Applies to vehicles: with Audi parking system plus with
front- and rearview camera
Fig. 174 Center console : P,•A button
Parking systems 149
Fig. 175 MMI disp lay: Select mo de
Switching on
.,. Switch the MMI on .
.,. Shift into reverse, or
.,. Press the
IP.1! button in the center console
¢
fig. 174. A short confirmation tone
sounds and the LED in the button lights up.
Selecting the mode
.,. Turn the control knob to the symbol for the
desired mode @ through @ ¢ fig.175.
Switching off
.,. Drive faster than 6 mph (10 km/h) , or
.,. Press the
l""'I button, or
.,. Switch off the ignition .
You may select from the following modes:
@ Topview ¢ page150
@ Corner view (front) ¢ page 150
© Front ¢ page 150
@ Rear o page 150
® Corner view (rea r) ¢ page 150
(D Tips
The visual display in the left part of the
display should help you detect the critical
vehicle areas.
To Next Page
Loading...
