Audio Analogue Absolute - Page 19

19
Remote control description
Remote Amp functions
The remote control is dedicated only to your ABsolute.
There are seven buttons:
 STBY : Turns ON and OFF the amplifier in the status in which it was
turned off
 SETUP : used for special functions, see further.
 MUTE : activates/de-activates the mute function.
 IN+ : input/turning on selection in class A mode
 IN- : input/turning on selection in class AB mode
 VOL+ : increases the volume of the unit.
 VOL- : decreases the volume of the unit.
Note: Please replace the remote control batteries in case the commands
from the remote control are not received correctly.
Unpacking and checking ABsolute package
Carefully open the wooden box to avoid damaging the content. The package should contain:
 1 ABsolute
 1 remote control
 1 power cord
 2 AAA batteries (already included in the remote control)
 1 instruction manual
If one of the items listed above is missing, please contact your Audio Analogue retailer. After extracting the
smaller items from the package, pull out the unit carefully. Separate the package from the anti-shock
expanded-foam protection. If batteries are not already placed in the remote control battery slot, open the slot;
insert batteries according to the indicated polarity, then close the battery slot.
Where to place the ABsolute
The ABsolute is a complex unit that may generate a lot of heat (especially when used in class A mode).
Please locate the unit in a well-ventilated place. In particular, leave at least 10 cm around and above the unit
and avoid placing it close to heat sources (radiators, heaters, amplifiers, television sets).