Audio Technica AT-SP3X User Manual

2
Note
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
−Reorient or relocate the receiving antenna.
−Increase the separation between the equipment and receiver.
−Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
−Consult the dealer or an experienced radio/TV technician for help.
This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter used
in other systems.
RF Exposure Statement
This device complies with FCC radiation exposure limits set forth for an uncontrolled environment and meets
the FCC radio frequency (RF) Exposure Guidelines. This equipment has very low levels of RF energy that it
deemed to comply without maximum permissive exposure evaluation. (MPE). But it is desirable that it should be
installed and operated keeping the radiator at least 20cm or more away from person’s body.
Contact
Responsible Company: Audio-Technica U.S., Inc.
Address: 1221 Commerce Drive, Stow, Ohio 44224, USA
Tel: 330-686-2600
For customers in Canada
ISED statement
This device complies with Part 15 of FCC Rules [ and contains license-exempt transmitter(s) that comply with
innovation，Science and Economic Development Canada’s licence-exempt RSS Standar(s)]. Operation is subject to
the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference received, including interference that may cause undesired operation
The digital apparatus complies with Canadian CAN ICES 3 (B)/NMB 3(B).
This device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and compliance with RSS
102 RF exposure, users can obtain Canadian information on RF exposure and compliance.
This equipment should be installed and operated with minimum distance 20mm between the radiator & your body.
L’appareil est conforme à la partie 15 des règles de la FCC [et contient des émetteurs exemptés de licence qui
répondent aux critères du CNR d’exemption de licence d’innovation, sciences et développement économique Canada].
Les opérations sont soumises aux deux conditions suivantes:
(1) Cet appareil ne peut pas causer d'interférence; Et
(2) Cet appareil doit accepter toute interférence reçue, y compris celles qui peuvent entraîner un fonctionnement
indésirable
Les appareils numériques sont conformes à la norme canadienne can ICES 3 (b) / NMB 3 (b).
L'appareil est conforme aux exigences d'exemption des limites d'évaluation de routine énoncées à la section 2.5 du
CNR 102 et aux exigences d'exposition aux radiofréquences du CNR 102, qui permettent aux utilisateurs d'obtenir des
renseignements canadiens sur l'exposition aux radiofréquences et la conformité.
Lors de l'installation et de l'utilisation de cet appareil, la distance minimale entre le radiateur et le corps doit être de 20
mm.

Audio Technica AT-SP3X Specifications

General

Brand	Audio Technica
Model	AT-SP3X
Category	Speakers
Language	English