EasyManuals Logo

Audio Technica ATH-ANC40BT User Manual

Audio Technica ATH-ANC40BT
88 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
5
English
How to Charge
How to Connect
Lit red:Charging
2 Connect the USB cable (the Type A side) to the computer and start charging.
3 During charging, the indicator operates as follows:
Fully charge the battery when using for the rst time.
When the rechargeable battery power runs low, you will hear a short beep and the indicator will ash red. When you hear
the beep, charge the battery.
It takes about 3 hours to charge the battery fully. (It varies depending on service conditions.)
* The headphones cannot be used during charging becauseBluetooth is disconnected.
To connect the headphones to a Bluetooth device, the headphones need to pair (register) with the device. Once they are
paired, you don't need to pair them again.
However, you will need to pair again in the following cases:
If the headphones are deleted from the Bluetooth device connection history,
If the headphones are sent out for repair,
If the headphones are paired with 9 devices or more.
(The headphones can be paired with up to 8 devices. When you pair with a new device after pairing with 8 devices, pairing
information for the device with the oldest connection date will be overwritten by information for the new device.)
About Pairing
USB port
USB charging cable (included)
Micro USB terminal
Battery
jack
Type A
Computer
Indicator
Off:Charging complete
1 Connect the included USB cable (the micro USB terminal side) to the headphone battery jack.
* Read the user manual for the Bluetooth device.
* Place the Bluetooth device within 1 meter of the headphones to perform pairing correctly.
* Wear the headphones to conrm pairing by listening for sound.
How to Perform Pairing
1 When these headphones are turned off, press and hold the power
 button until the indicator on the Bluetooth transmitter/receiver
 ashes red/blue (about 6 seconds).
* For more information on how to use the Bluetooth device, read the operation manual for the device.
2 Pairing process will begin and the Bluetooth device will search for the headphones.
2nd beep
1st beep
A 2-second pause
Long press

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Audio Technica ATH-ANC40BT and is the answer not in the manual?

Audio Technica ATH-ANC40BT Specifications

General IconGeneral
ManualYes
Power handling0.01 W
Brand compatibilityAny brand
Battery typeBuilt-in battery
Standby time100 h
Charging time3 h
Battery voltage3.7 V
Charging sourceUSB
Continuous audio playback time24 h
Microphone typeNot available
Microphone frequency70 - 8000 Hz
Detachable microphoneNo
Microphone sensitivity-42 dB
Microphone direction typeOmnidirectional
Impedance16 Ω
Driver unit13.5 mm
Ear couplingIntraaural
Headphone frequency20 - 24000 Hz
Maximum input power10 mW
Headphone sensitivity100 dB
Cables includedAudio (3.5mm), USB
Cable length1.2 m
Headset typeBinaural
Product typeHeadset
Product colorBlack
Wearing styleNeck-band
Volume controlDigital
Recommended usageMusic
Bluetooth version3.0+HS
Bluetooth profilesA2DP, APT-X, AVRCP, HFP, HSP
Connectivity technologyWireless
Weight and Dimensions IconWeight and Dimensions
Weight35 g

Related product manuals