6
Connecting via Bluetooth wireless technology
About pairing
Pairing a Bluetooth device
To connect the product to a Bluetooth device, the product needs to pair (register) with the device. Once they are
paired, you do not need to pair them again.
However, you will need to pair again in the following cases:
• If the product is deleted from the Bluetooth device’s connection history.
• If the product is sent out for repair.
• Read the user manual for the Bluetooth device.
• Place the device within 1 m (3.3') of the product to perform pairing correctly.
• To confirm the progress of the pairing process, wear the product while performing this procedure and listen for the
confirmation tone.
1. Starting with the product turned off, slide the power switch to the “ON” position.
• The indicator lamp will light in purple, and then flash in red and blue.
2. Use your Bluetooth device to begin the pairing process and search for the product.
When your Bluetooth device finds the product, "ATH-CKR35BT" will be displayed on the device.
• For information about using your Bluetooth device, refer to the device’s user manual.
3. Select "ATH-CKR35BT" to pair the product and your Bluetooth device.
• Some devices may ask for a passkey. In this case, enter “0000”. The passkey
may also be called a passcode, PIN code, PIN number, or password.
• The product sounds a confirmation tone when pairing is complete.
100%12:00
Bluetooth ON
ATH-CKR35BT
To Next Page
Loading...
Need help?
General
