How to Connect
How to Charge
English
Computer
USB port
USB charging cable (included)
Micro USB terminal
Type A
Battery
jack
1
Connect the included USB cable (the micro USB
terminal side) to the headphone battery jack.
Flashes blue twice: Charging just started
Lit red: Charging
Off: Charging complete
2
Connect the USB cable (the Type A side) to the computer and start charging.
3
During charging, the indicator turns on/ashes as follows:
Fully charge the battery when using for the rst time.
When the rechargeable battery power runs low, you will hear a short beep and the indicator will
ash red. When you hear the beep, charge the battery.
It takes about 3 hours to charge the battery fully. (It varies depending on service conditions.)
* The headphones cannot be used during charging because
Bluetooth
is disconnected.
To connect the headphones to a
Bluetooth
device, the headphones need to pair (register) with the
device. Once they are paired, you don't need to pair them again.
However, you will need to pair again in the following cases:
・
If the headphones are deleted from the
Bluetooth
device connection history,
・
If the headphones are sent out for repair,
・
If the headphones are paired with 9 devices or more.
(The headphones can be paired with up to 8 devices. When you pair with a new device after pairing
with 8 devices, pairing information for the device with the oldest connection date will be overwritten
by information for the new device.)
About Pairing
* The included USB cable is specically designed to charge the headphones.
Data cannot be transferred to and from computer.
7
To Next Page
Loading...
Need help?
General
Weight and Dimensions
