AudioBahn A4401T - User Manual

Details how to connect speakers to the amplifier's output terminals for various models.

Explains setting the input gain level to match source unit output for optimal performance.

Describes the RCA inputs used for receiving audio signals from the head unit.

Details the RCA outputs for daisy-chaining multiple amplifiers or sending signal to other devices.

Covers the bass enhancement feature, its on/off switch, and the variable boost control.

Explains the settings for high-pass (HPF), low-pass (LPF), and full-range crossover filters.

Details the essential connection for the amplifier's negative ground to the vehicle's chassis.

Explains the direct connection to the vehicle's positive battery terminal for power.

Describes the terminal used to remotely turn the amplifier on and off with the head unit.

Adjusts the crossover frequency for subwoofer channels, filtering high frequencies.

Adjusts the crossover frequency for subwoofer channels, filtering high frequencies.

Adjusts the crossover frequency for subwoofer channels, offering band-pass capability.

Filters low frequencies for mid-high range channels, suitable for specific speaker types.

Filters low frequencies for mid-high range channels, offering band-pass capability.

Controls the subsonic filter to remove inaudible ultra-low frequencies that can distort.

Adjusts the crossover frequency specifically for subwoofer channels.

Allows adjustment of the subwoofer's phase (0 or 180 degrees) for timing alignment.

Alternative control for adjusting the subwoofer's phase between 0 and 180 degrees.

Selects the input configuration for the amplifier, such as 2, 4, or 6 channel operation.

Explains the function of the Power (PWR) and Protection (PROT) indicator lights.

Details external remote control features, likely for subwoofer level adjustment.

Controls the illumination feature of the amplifier, such as LEDs or backlighting.

Illustrates mono and stereo wiring configurations for the A1801T amplifier model.

Shows mono and stereo wiring for multiple amplifier models, including A2201T through A3201T.

Details the tri-mode wiring setup for the A2201T through A3201T amplifier series.

Provides wiring diagrams for 2, 3, and 4 channel configurations for A4401T-A4801T models.

Illustrates the wiring configuration for the 6 channel mode of the A4401T-A4801T amplifiers.

Shows mono, center, front, and rear mode wiring connections for the A5100T amplifier.

Details wiring configurations for 3, 4, and 5 channel modes for the A6601T amplifier.

Provides wiring diagrams for 6 and 7 channel modes for the A6601T amplifier.

Illustrates wiring configurations for 8 and 9 channel modes of the A6601T amplifier.

Explains the automatic amplifier turn-on sequence and important power requirements.

Guides users on setting the amplifier's input gain for optimal audio signal levels.

Provides critical safety instructions for installation and operation to prevent damage or injury.

States that product specifications are subject to change without prior notice.