Need help?Do you have a question about the AudioBahn A4601T and is the answer not in the manual?
Illustrates and describes the speaker terminal connections for various amplifier models.
Explains how to adjust the amplifier's input sensitivity for optimal performance.
Details Low Level Input and Output RCA jacks for audio signal connection.
Explains Bass Boost switch and Crossover filter settings for sound shaping.
Covers essential power, ground, and remote turn-on terminal connections.
Details Low-pass and High-pass filter controls for frequency range adjustments.
Covers Sub Sonic filter, X-Over frequency, and Phase Shift controls for sound tuning.
Explains input mode selection, phase shift switch, LED indicators, and remote control.
Wiring diagram for the A1801T amplifier in Mono mode.
Diagrams for Mono, Stereo, and Tri-Mode setups for specific models.
Diagrams for 2, 3, and 4 Channel modes for these models.
Diagrams for Mono, Center, Front, and Rear modes for the A5100T.
Diagrams for 3 through 9 Channel modes for the A6601T.
Explains the amplifier's automatic turn-on sequence and LED indicators.
Guides users on adjusting the amplifier's gain for best audio signal levels.
General| Channels | 4 |
|---|---|
| Crossover Frequency | 50Hz - 250Hz |
| Input Voltage | 12V |
| Fuse Rating | 30A |
| Input Sensitivity | 200mV - 6V |
| Dimensions | 14.5" x 10.5" x 2.5" |
| RMS Power at 4 Ohms | 60W x 4 |
| RMS Power at 2 Ohms | 90W x 4 |
| Bridged RMS Power at 4 Ohms | 180W x 2 |
| Total RMS Power | 360 Watts |
| Power Output (Peak) | 120W x 4 |
| Signal-to-Noise Ratio | > 100 dB |
| THD | < 0.1% |
| Signal to Noise Ratio | > 100 dB |
To Next Page
