To Next Page
K
Kelly BrownJul 29, 2025
What to do if the AudioBahn A12001DT fuse is broken?
- BBradley WhiteJul 29, 2025
If the fuse is broken, replace it.
What to do if the AudioBahn A12001DT fuse is broken?
If the fuse is broken, replace it.
How to troubleshoot if the power LED is not illuminated on my AudioBahn Car Amplifier?
If the power LED is not illuminated, take the following steps: * Check the fuses in the amplifier. * Ensure the Turn-on lead is connected. * Check the signal leads. * Verify the gain control. * Check the Tuner/Deck volume level. * Clean the contacts on the fuse holders.
What should I do if the speaker wires are shorting in my AudioBahn A12001DT Car Amplifier?
If the speaker wires are shorting, separate the speaker wires and insulate them.
What to do if there's no power to the power wire of my AudioBahn A12001DT?
If there's no power to the power wire, repair the power wire or its connections.
What does it mean if the diagnostic LED is illuminated on my AudioBahn A12001DT Car Amplifier?
If the diagnostic LED is illuminated, check for a speaker short or amplifier overheating.
How do I check the speaker leads on my AudioBahn A12001DT?
Inspect the speaker leads for a short circuit or an open connection.
Why is there no power to the remote wire with the receiver on in my AudioBahn A12001DT Car Amplifier?
If there's no power to the remote wire with the receiver on, check the connections to the radio.
Connects amplifier to remote bass knob using supplied cable.
Adjusts amplifier's input sensitivity; not a volume control.
Inputs for signal cables from the source; use shielded RCA cables.
Allows building multi-amplifier systems by feeding signal to next amplifier.
Emphasizes bass notes at 45Hz up to 18dB.
Adjusts subwoofer phase (0-180 degrees) for timing compensation.
Filters frequencies above 50Hz-150Hz for subwoofer channel.
Cuts frequencies below set point to protect subwoofers from harm.
Connects two amplifiers for increased power; requires specific switch settings.
Turns external lights on/off; internal lights stay on when off.
Terminals for wiring subwoofer(s) to the amplifier.
Grounds amplifier to vehicle chassis to prevent ignition noise.
Connects to positive battery terminal; requires in-line fuse for safety.
Connects to car stereo remote turn-on wire to remotely power amplifier.
PWR (Blue) indicates power on; PROT (Red) indicates protection mode.
Considers system expansion, component matching, and lead routing.
Discusses amplifier placement for heat dissipation and ventilation.
Essential for proper operation; incorrect adjustment can damage amplifier/speakers.
Safety precautions for installation, wiring, and fuse replacement.
Specifications subject to change; contact for updates.
Details warranty coverage, period, and required documentation.
Lists items and conditions not covered by the Audiobahn warranty.
General| Channels | 1 |
|---|---|
| RMS Power at 1 Ohm | 1200W x 1 |
| Frequency Response | 10 Hz - 250 Hz |
| THD at RMS Output | <0.1% |
| Signal to Noise Ratio | >90 dB |
| Damping Factor | >200 |
| Input Sensitivity | 0.2V - 6V |
| Bass Boost | 0dB - 18dB |
| Crossover Frequency | 50 Hz - 250 Hz |
| Power Output (Peak) | 2400W |
