Need help?Do you have a question about the AudioBahn ABD40J and is the answer not in the manual?
Controls for adjusting center frequency and frequency range.
Features recreating low frequencies and LED indicators for circuit status.
Wired control for remote adjustment of the processor's level.
Key technical parameters and performance metrics of the ABD40J.
Details on balanced input, RCA outputs, and remote control connections.
Instructions for connecting the unit's power and ground wires.
Knobs to adjust the bass processor's center frequency and frequency range.
Switch for selecting PFM subsonic filter frequencies for speaker protection.
LED indicators for bass maximization and unit power-on status.
Jumper settings for balanced or unbalanced ground input configuration.
Jumper for isolating alternator noise from the audio system.
Jumpers to adjust signal restoration for SPL or output maximization.
Connect the red wire to the car battery or other 12V power source.
Connect the orange cable to the car's stereo remote trigger.
Connect the black wire to the vehicle chassis for proper grounding.
Steps to diagnose and resolve common unit operational problems and errors.
Precautions for safe drilling, wiring, and mounting of the unit in a vehicle.
Guidelines for correctly replacing the unit's power fuse with the proper type.
Details manufacturer defect coverage, warranty period, and transferability.
Lists conditions, damages, and product types not covered by the warranty.
Steps for obtaining warranty service, including Return Authorization (RA) number requirements.
Headquarters contact details including address, phone, fax, and email.
General| Channels | 4 |
|---|---|
| THD at Rated RMS Power | <0.05% |
| Fuse Rating | 25A |
| Input Sensitivity | 200mV - 6V |
| Crossover Frequency | 50Hz - 250Hz |
| Crossover | Variable High-Pass/Low-Pass |
To Next Page
