AudioCodes 450HD - Installation Guide Manual

AudioCodes 450HD IP Phone Expansion Unit
Installation Guide
1 | Page
1. Before Installing
Congratulations on purchasing the Expansion Module for your AudioCodes 450HD IP Phone!
Before installing it, make sure the following items are included in the shipped box:
 Expansion Module
 Kit containing five screws
2. Installation Process
Note: Before proceeding with the installation:
• Disconnect the phone from the Power Supply / Power over Ethernet (PoE)
• Obtain a Philips screwdriver
 To connect the Expansion Module to the 450HD phone:
 Step 1: Prepare the two units – see here
 Step 2: Remove the phone’s side panel – see here
 Step 3: Connect the Expansion Module to the phone – see here
 Step 4: Attach the panel removed from the phone in Step 3, to the Expansion Module – see here
 Step 5: Secure the assembly – see here
 Step 6: Install the Expansion Module's base stand and the phone's base stand - see here
 Step 7: Mount the assembled unit - see here