AudioCodes Mediant 500L - Physical Description

2 | Page
Physical Description
[The number and type of port interfaces depend on the ordered hardware configuration.]
1
POWER
AC power plug entry
Power LED (located on the front panel):
Green On
Power received by device
Off
No power
Status LED (located on the front panel):
Green On
Device is operational
Green Flashing
Initial rebooting stage or software upgrade (.cmp
file) in process
Red On
Boot failure
Off
Advanced rebooting stage
2
ON / OFF
Power button to switch on the device (when pressed in) and to switch off the
device (when pressed out).
3
CONSOLE
RS-232 serial interface port (RJ-45).
4
USB port, which you can use for various functionalities such as storing the
configuration file on an external USB hard drive.
5
//
Reset pinhole button for resetting the device or restoring it to factory defaults. To
restore the device to factory defaults: with a paper clip or any other similar
pointed object, press and hold down the button for at least 12 seconds (but no
more than 25 seconds).
6
S1 GE LAN
Up to four Gigabit Ethernet (10/100/1000Base-T) ports (RJ-45) for connecting IP
phones, computers, or switches. The ports support 1+1 Ethernet port redundancy
(active-standby), half- and full-duplex modes, auto-negotiation, and straight-
through or crossover cable detection.
Green On
Ethernet link established
Green Flashing
Data is being received or transmitted
Off
No Ethernet link
1
2
3
4
5
6