BroadCloud SIP Trunk
AudioCodes Mediant BRI/PRI Gateway 16 Document #: LTRT-12393
Figure 2-18: Cabling E1/T1 Ports
2.3.5 Powering up
The device receives power from a standard alternating current (AC) electrical outlet. The
connection is made using the supplied AC power cord.
Table 2-12: Power Specifications
Physical Specification Value
Input Voltage Single universal AC power supply 100 to 240V
AC Input Frequency 50 to 60 Hz
AC Input Current 1.5A
Warning:
• The device must be connected to a socket-outlet providing protective earthing.
• Use only the AC power cord that is supplied with the device.
To connect the device to the power supply:
1. Connect the line socket of the AC power cord (supplied) to the device's AC power
socket (labeled 100-240V 1.5A ~50-60 Hz), located on the rear panel.
Figure 2-19: Connecting to the Power Supply
2. Connect the plug at the other end of the AC power cord to a standard electrical outlet.
After cabling and powering up, the POWER LED on the front panel lights up green.
To Next Page
Loading...
