BroadCloud SIP Trunk
AudioCodes Mediant BRI/PRI Gateway 18 Document #: LTRT-12393
2. Change the IP address and subnet mask of your computer to correspond with the
default OAMP IP address and subnet mask of the device.
3. Access the Web interface:
a. On your computer, start a Web browser and in the URL address field, enter the
default IP address of the device; the Web interface's Web Login screen appears:
Figure 3-2: Web Login Screen
b. In the 'Username' and 'Password' fields, enter the case-sensitive, default login
username (Admin) and password (Admin).
c. Click Login.
3.2.1 Change Default Management User Login Passwords
To secure access to the device's Web management interface, follow these recommended
guidelines:
The device is shipped with a default Security Administrator access-level user
account – username 'Admin' and password 'Admin'. This user has full read-write
access privileges to the device. It is recommended to change the default password to
a hard-to-hack string. The login username and password are configured in the Web
interface's User Accounts page (Configuration tab > System > Web User Accounts)
using the 'Current Password', 'New Password', and 'Confirm New Password' fields, as
shown below:
Figure 3: Changing Password of Default Security Administrator User
The device is shipped with a default Monitor access-level user account - username
'User' and password 'User'. This user only has read access privileges to the device.
The read access privilege is also limited to certain Web pages. However, this user can
view certain SIP settings such as proxy server addresses. Therefore, to prevent an
attacker from obtaining sensitive SIP settings that could result in possible call theft
etc., change the access level of this user to No Access (see the figure below). In
addition (or alternatively), change its default login password to a hard-to-hack string.
Figure 4: Changing Access Level to No Access of Default Monitor User
To Next Page
Loading...
Need help?
General
