AudioCodes Mediant Series User Manual

BroadCloud SIP Trunk
AudioCodes Mediant BRI/PRI Gateway 22 Document #: LTRT-12393
Figure 4-6: Software Upgrade Wizard – Files Loaded
11. Click Reset to burn the files to the device's flash memory; the 'Burn and reset in
progress' message is displayed and the device 'burns' the newly loaded files to flash
memory and then resets.
Note: Reset may take a few minutes (even up to 30) depending on .cmp file version.
When the device finishes the installation process and resets, the following wizard
page is displayed, showing the installed software version and other files (ini file and
auxiliary files) that you may also have installed:
Figure 4-7: Software Upgrade Process Completed Successfully
12. Click End Process to close the wizard; Web Login is displayed.
13. Enter your login username and password (Admin, Admin respectively), and then click
Login; a message box appears informing you of the new .cmp file version.
14. Click OK; the Web interface becomes active, reflecting the upgraded device.

AudioCodes Mediant Series Specifications

General

Model	Mediant Series
Category	Gateway
VoIP Protocols	SIP, H.323, MGCP
Interfaces	E1/T1, BRI
Network Interfaces	10/100/1000 Ethernet
Security	TLS
Management	Web, CLI, SNMP
Codecs	G.711, G.723, G.726, G.729, iLBC, Opus
Operating Temperature	0°C to 40°C
Storage Temperature	70°C
Ports	Varies by model (FXS, FXO, BRI, E1/T1, Ethernet)