1 | Page
MediaPack™ 124 Analog VoIP Gateway
Quick Setup Guide
Welcome
Congratulations on purchasing your AudioCodes MediaPack 124 (MP-124 Rev. E) Analog Voice-over-IP (VoIP)
Media Gateway (hereafter, referred to as device)!
This document is only intended to provide basic setup instructions for initial access to the device and
connecting it to your network. For advanced configuration and cabling, refer to the User's Manual and
Hardware Installation Manual respectively, which can be downloaded from AudioCodes website at
https://www.audiocodes.com/library/technical-documents.
Before you begin, please read the Safety Precautions on page 7.
Package Contents
Make sure that the following items (in addition to any separate-orderable items that you may have purchased)
are included with your shipped device:
2 x short equal-length brackets and bracket-to-device screws for 19-inch rack installation
(AC-powered model) 1 x AC power cord
(DC-powered model) 1 x unwired DC terminal block with 2 x crimping screws
Regulatory Information document
This document
To Next Page
