To Next Page

To Previous Page

Configuration Note 2. Restoring Defaults using CLI

Version 6.4 11 May 2012

2.2.2 MP-11x, Mediant 600, Mediant 1000, Mediant 2000, and Mediant

3000

For the MP-11x, Mediant 600, Mediant 1000, Mediant 2000, and Mediant 3000 devices,

follow the procedure below.

 To restore factory defaults:

1. At the CLI prompt, type the following command to access the configuration mode, and

then press the Enter key:

# conf

2. At the prompt, type the following command to reset the device to default settings, and

then press the Enter key:

# RestoreFactorySettings

The CLI commands mentioned in the procedure are shown in the terminal emulation

program (HyperTerminal) below:

Figure 2-2: CLI for Resetting Device to Default (Non-MSBG Devices)

AudioCodes MediaPack MP-11 Series Configuration Note

Other manuals for AudioCodes MediaPack MP-11 Series