AudioEngine A2+ User Manual

~Paudioengine
As
the
A2+ speakers have
the
power amplifiers
built
inside,
do
not
connect
the
speaker
terminals
to
the
speaker outputs
of
a
stereo receiver.
Step
2-
Connecting the Power
Supply
o
C>k"
[
'
Power
cord connection
Verify
that
the
volume/power switch on
the
rear panel
of
the
left
speaker
is
in the
OFF
position by rotating
it
counterclockwise
until
it
clicks
off.
1.
Connect
the
cable from
the
power
supply
to
the
left
speaker
rear
panel.
2.
Connect
the
power cable
to
the
other
end
of
the
power
supply.

AudioEngine A2+ Specifications

General

Outputs	RCA variable line-out
Frequency Response	65Hz-22kHz ±2.0dB
Signal-to-Noise Ratio	>95dB (typical A-weighted)
Total Harmonic Distortion	<0.05% at all power settings
Type	Powered speakers
Amplifier Type	Class AB
Power Output	60W peak power total (15W RMS / 30W peak per channel)
Drivers	2.75" aramid fiber woofers, 3/4" silk dome tweeters
Inputs	3.5mm stereo mini-jack, RCA
Dimensions	6" x 4" x 5.25" (H x W x D)
Input Voltage	100-240V, 50/60Hz
Input Impedance	10k ohms
Protection	thermal protection