Audiolab 8000P User Manual

a u d i o l a b
International Audio Group
IAG house,
Sovereign Court,
Ermine Business Park
Huntingdon, PE29 6XU
S p e c i f i c a t i o n
8 0 0 0 P
Power Amplifier
Rated output power
Typical output power
Input for full rated power
Input impedance
Gain
Signal to noise
Frequency response (-3 dB)
Frequency response (±0.3dB)
Total harmonic distortion + noise
Dimensions (WxHxD - mm)
100 W per channel into rated load impedance (8Ω), 150 W into 4Ω
120 W per channel into rated load impedance (8Ω), 180 W into 4Ω
1.0 V rms
47 kΩ nominal
29.0 dB at 1 kHz
Greater than 95 dB (relative to 0 dBW)
0.1 Hz - 75 kHz
20 Hz - 20 kHz
Less than 0.05%
445 x 74 x 337
The 8000P is a classic two-channel power
a m p l i f i e r, delivering over 100W per
channel and a peak output of over 40
Amps.
Comfortably able to drive most
loudspeaker loads, the 8000P is equally
useful in Home Cinema configurations
as it is in high performance stereo
applications.
A simple aesthetic and wide compatibility
with other components ensures the 8000P
amplifier is an ideal building block for
your current and future systems.
All Audiolab 8000 series power amplifiers
are gain-matched for easy integration into
a growing system.

Audiolab 8000P Specifications

General

Power Output	100W per channel into 8 Ohms
Signal to Noise Ratio	> 100dB
Dimensions	445 x 74 x 335 mm
Gain	29dB
Total Harmonic Distortion	<0.05%

Summary

8000P Power Amplifier Specification

Rated Output Power

Output power delivered per channel into specified load impedances.

Typical Output Power

Typical power output per channel into specified load impedances.

Input for Full Rated Power

Input voltage level required for the amplifier to reach its full rated power.

Input Impedance

The electrical impedance presented at the amplifier's input terminals.

Gain

Amplification factor measured in decibels at a specific frequency.

Signal to Noise Ratio

Ratio of the desired signal power to the noise power, expressed in dB.

Frequency Response (-3 dB)

Frequency range over which the output power drops by 3 dB from the nominal level.

Frequency Response (±0.3 dB)

Frequency range over which the output power is maintained within ±0.3 dB.

Total Harmonic Distortion + Noise

Measure of unwanted harmonic frequencies and noise present in the output signal.

Dimensions (WxHxD - mm)

Physical dimensions of the amplifier in millimeters (Width, Height, Depth).