Need help?Do you have a question about the Audiolab 8000M and is the answer not in the manual?
General| Type | Mono Power Amplifier |
|---|---|
| Frequency Response | 20Hz - 20kHz ±0.5dB |
| Signal to Noise Ratio | > 100dB |
| Total Harmonic Distortion | < 0.05% |
| Input Impedance | 47k Ohms |
| Dimensions | 74 x 445 x 335mm |
Details of the Audiolab limited warranty, including coverage, conditions, and exclusions.
Instructions on how to obtain warranty service, including packaging and shipping advice.
Guidelines for safe connection to mains power, fuse replacement, and earthing.
Specific safety instructions and plug wiring advice for users in the United Kingdom.
Detailed technical specifications for the 8000Q pre-amplifier, including inputs, outputs, and performance.
Detailed technical specifications for the 8000P power amplifier, including output power and frequency response.
Detailed technical specifications for the 8000M power amplifier, including output power and frequency response.
Procedure for powering the system on and off, including pre-amplifier and power amplifier sequence.
Introduction to the 8000Q pre-amplifier controls, including Gain Switch, Volume, and Input Selector.
Guide to connecting the 8000Q pre-amplifier to various audio sources and outputs.
Instructions for connecting 8000P and 8000M power amplifiers to pre-amplifiers and speakers.
Methods for connecting loudspeakers to the 8000M amplifier, including standard and bi-wiring.
Methods for connecting loudspeakers to the 8000P amplifier, including bi-amplified setups.
To Next Page
