Audiolab 8000X7 User Manual

a u d i o l a b
International Audio Group
IAG house,
Sovereign Court,
Ermine Business Park
Huntingdon, PE29 6XU
The 8000X7 is a genuine one-box, seven
channel power amplifier, capable of handling
even difficult loudspeaker loads.
The 8000X7 home theatre power amplifier
delivers 7 x 100Wrms power. However, you
can also run it in five or six channel mode too.
By bridging two channels it is possible to
create a more powerful single channel -
especially useful if your front left and front
right speakers are more performance critical
than the other speakers in your 5.1 system.
Power output
IHF toneburst power
Input for rated power
Input impedance
Gain
Signal to noise
Frequency Response
Input connector
7 x 100W into rated load impedance (8 Ohm)
5 x 100W and 1 x 150W (8 Ohm)
3 x 100W and 2 x 150W (8 Ohm)
7 x 120W (8 Ohm)
1.05 Vrms
47 kOhm
+29 dB at 1 kHz
better than 90 dB (relative to 0 dBW) unweighted
1.5 Hz - 150 kHz (-3 dB)
RCA
S p e c i f i c a t i o n
8 0 0 0 X 7
Power Amplifier
“Unobtrusive, with an elegant
simplicity, the 8000X7 is a
compact yet powerful performer.”

Audiolab 8000X7 Specifications

General

Brand	Audiolab
Model	8000X7
Category	Amplifier
Language	English

Summary

8000X7 Power Amplifier Overview

Product Description

The 8000X7 is a seven-channel amplifier, capable of handling difficult loads and bridging channels for increased power.

Technical Specifications

Power Output

Details the power output in various channel configurations: 7x100W, 5x100W+1x150W, 3x100W+2x150W into 8 Ohm loads.

IHF Toneburst Power

Specifies the IHF toneburst power output as 7 x 120W into an 8 Ohm load.

Input for Rated Power

Indicates the input voltage required for rated power output, specified as 1.05 Vrms.

Input Impedance

States the input impedance of the amplifier, which is 47 kOhm.

Gain

Provides the amplification gain value, measured as +29 dB at 1 kHz.

Signal to Noise Ratio

Specifies the signal-to-noise ratio as better than 90 dB (unweighted, relative to 0 dBW).

Frequency Response

Defines the frequency response range as 1.5 Hz to 150 kHz (-3 dB).

Input Connector

Identifies the type of input connector used, which is RCA.