Need help?Do you have a question about the Audiolab 9000A and is the answer not in the manual?
General| Power Output | 100W per channel (8 ohms) |
|---|---|
| Type | Integrated Amplifier |
| Preamp Output | Yes |
| Output Power (4 ohms) | 160W per channel |
| DAC Resolution | 32-bit |
| Frequency Response | 20Hz - 20kHz |
| Signal-to-Noise Ratio | > 111dB (A-weighted) |
| Outputs | Speaker terminals, preamp output, headphone output |
| Dimensions | 444 x 89 x 342 mm |
| DAC | ESS Sabre ES9038Pro |
| Digital Inputs | 2 x Optical, 2 x Coaxial, 1 x USB |
| Analogue Inputs | 4 x RCA, 1 x XLR |
| Phono Input | MM/MC |
| Bluetooth | Yes, aptX |
| Speaker Outputs | Yes |
| Headphone Output | Yes |
| Display | LCD |
| Input Impedance | 47k ohms |
| Output Impedance | 100 Ohms (Pre Out) |
| USB Audio | Yes |
| Inputs | 6 x analogue, 4 x digital |
Regulatory compliance statement for FCC rules.
Evaluation of device RF exposure requirements.
Regulatory compliance statement for ISED Canada.
Information on downloading drivers and updating firmware.
Configure digital filter for the DAC.
Control automatic upsampling of digital audio signals.
Adjust digital phase lock loop bandwidth.
Adjust input sensitivity of analogue inputs.
Set maximum volume level on power on.
Reset the unit to factory default settings.
How to register the product for warranty online.
Items and conditions not covered by the warranty.
Steps to follow when making a warranty claim.
Information on how repairs are handled under warranty.
Contact details for service and support.
To Next Page
