Need help?Do you have a question about the Audiolab M-ONE and is the answer not in the manual?
General| Type | Integrated Amplifier |
|---|---|
| DSD Compatibility | Yes (DSD64, DSD128, DSD256) |
| DAC | ESS Sabre32 ES9018K2M |
| Inputs | Optical, Coaxial, USB, Bluetooth, Analog RCA |
| Outputs | 1 x Headphone |
| Frequency Response | 20Hz - 20kHz |
| Sampling Rate | Up to 384kHz |
| Bluetooth | Yes |
| Headphone Output | Yes (6.3mm) |
| Input Sensitivity | 200mV |
| Input Impedance | 10kΩ |
| Frequency Response Variation | +/- 0.5dB |
| Signal-to-Noise Ratio | >110dB |
Warnings about electric shock and not opening the enclosure for safety.
Warnings regarding battery replacement, heat exposure, and disposal.
Information on electrical ratings, terminal safety, mains voltage, and double insulation.
Description of controls on the front panel of the M-ONE amplifier.
Identification of all input and output connectors on the rear panel.
How to connect analogue sources and headphones to the M-ONE.
Procedures for turning the unit on/off and using standby mode.
Instructions for playing audio files from a USB source via the M-ONE.
How to wirelessly stream music via Bluetooth to the M-ONE.
To Next Page
