Audiolab M-ONE User Manual

5; !Sfnpuf!Iboetfu!
Page 4
1 MUTE Press to mute and unmute the sound
2 VOL+ Increase Volume
3
Move to the next track of CD/USB
Move to next page or setting in menu
4
Press to start/pause CD/USB
Press to confirm page or setting selected in menu
5 DISPLAY Press to cycle through display options
6
Press to select next source
7
Press to select previous source
8 MENU Press to enter or exit menu
9 VOL– Decrease Volume
10
Press once to replay the current track of CD/USB
Press again to move to the previous track of CD/USB
11 STANDBY Press to bring the unit in/out of Standby
Battery Caution
• There is a risk of fire and burns if the battery is handled improperly
• Do not disassemble, crush, puncture, short external contacts or dispose in fire or water.
• Do not attempt to open or service the battery. Replace only with a CR2025 battery.
• Discard used batteries in accordance with recycling regulations in force in your area
Preparing the Handset
• Unpack the handset
• Invert the handset
• Remove the battery cover
• Place a new battery as shown
• Close the battery cover
$+021(LQGG 

Audiolab M-ONE Specifications

General

Type	Integrated Amplifier
DSD Compatibility	Yes (DSD64, DSD128, DSD256)
DAC	ESS Sabre32 ES9018K2M
Inputs	Optical, Coaxial, USB, Bluetooth, Analog RCA
Outputs	1 x Headphone
Frequency Response	20Hz - 20kHz
Sampling Rate	Up to 384kHz
Bluetooth	Yes
Headphone Output	Yes (6.3mm)
Input Sensitivity	200mV
Input Impedance	10kΩ
Frequency Response Variation	+/- 0.5dB
Signal-to-Noise Ratio	>110dB