Audiolab DSP-2600 - Output EQ Setting

DSP-2600
P. 13
ENGLISH VERSION
8.EQSetting:
 Parameter EQ, OUT1-OUT8 Each channel can
set 6 parameter EQ (EQ1-EQ6).
Example
A. Atparameterstatus:
Freq: 20Hz-20Khz
Gain: -20dB-+15dB
Bandwidth: 0.05/Oct-3/Oct
B. At Lo_Shelf, Hi-shelf status:
Freq: 20Hz-20Khz
Gain: -30dB-+15Db
Slope:+6dB, +12dB
 Example:
1. Press OUT1 channel for 3 seconds till yellow
light displays into Edit status of OUT1.
2. Press“<BACK”or“NEXT>, switch to EQ, into
“Parameter” setting status.
 Displaynext:
3. Turn the rst knob of “PARA”, can switch to
“Lo-shelf” or “Hi-shelf” setting status. Press
ENTER to conrm.
 Displaynext
4. Press “ENTER”,conrm select “Lo-Shelf”,into
parameter setting. Turn the rst knob of “PARA”
to adjust gain value, Turn the second knob to ad
justFreq, Turn the third knob to select slope. (Turn
the knob clockwise, the value increase; Turn the
knob withershins, the value decrease).
Displaynext:
5. Press “<BACK”or“NEXT>”, can switch among
EQ1-EQ6,the setting method is the same.