34
Settings
5 Set the first digit for your area code using the Up key ▲ or the Down
key ▼.
6 Press the Set key to confirm.
7 Use the same method to set the following digits. After each setting press
the Set key to confirm.
If you don’t want to do further settings, the phone
will return to idle state after approx. 12 seconds.
Setting the LCode (Call-by-Call provider)
You can enter e. g. the telephone number (prefix) of a call-by-call
provider. This telephone number will be automatically dialled in front
of a calls list entry in case you call back from the list (see page 44), if
you press the redial key twice instead of lifting the receiver or pressing
the handsfree button.
1 The receiver is placed on the base.
2 Press the Set key.
3 Press the Up key ▲ twice.
The display shows 3 0.
4 Press the Set key, the current setting is shown.
5 If necessary delete the digits using the Delete key and enter the correct
code using the digit keys.
6 Press the Set key to confirm.
Setting the LCD contrast
1 The receiver is placed on the base.
2 Press the Set key.
3 Press the Up key ▲ three times.
The display shows .
To Next Page
Loading...
